- Finally the assembly starts with steps fitted to the rails and glued, the 5/16” threaded rods are inserted and washer with nut attached to each rod end; the toe boards are fitted, glued and slide into place. The final step is securing the nuts on the rods to tighten the assembly.
- IMG_1643.JPG (110.09 KiB) Viewed 5045 times
- Looking at the underside of the bottom step you see the two support rods traverse the lower step securing the step between the risers.
- IMG_1645.JPG (104.97 KiB) Viewed 5045 times
- From the side view you can see the support rods as they terminate to the outside of the riser. Note the rounded nose on each step.
- IMG_1644.JPG (126.24 KiB) Viewed 5045 times
- This shows the underside of the staircase and the two rods that support each step.
- IMG_1646.JPG (118.36 KiB) Viewed 5045 times
