Friends of the Cumbres & Toltec - FriendsOfCumbresToltec.org
A Place for Those Born Too Late...
WORK SESSION A - Friday, May 24, 2014
First unread post • 2 posts
• Page 1 of 1
WORK SESSION A - Friday, May 24, 2014
by Linda Smith » Sat May 24, 2014 10:40 am
MORE PHOTOS FROM ED LOWRANCE FROM WORK SESSION A - enjoy!
- Attachments
-
- An entire container is being dedicated to parts for the trucks project - both metal and wood. To make the best use of space, volunteers are installing shelving across the end of the container. Also, a track with electric hoist will be installed to facilitate handling heavy parts. The large wooden panels at the rear are patterns for parts that have been cast - and might need to be used for additional units in the future.
-
- John Weiss, foreground, and Russ Hanscom (background) are grinding welds on truck elements.
-
- Making room! A gang is moving a very heavy work table to make some room in our crowded CRF; seven guys move this work bench. Malcolm Mackey builds them stout!
-
- Lousy weather, including cold winds, slowed gable end work on the new car shelter; however, by the end of the workday on Friday, all but one panel was in place.
-
- Earlier this week: while installing the gooseneck trailer hitch on the Ford, some BAD problems were identified with the drive train and muffler assembly. (L-R) Marshall Smith and Jim McGee rebuilt the drive train and a local La Jara repairman installed a new muffler tailpipe assembly.
- Linda Smith
- Brakeman
- Posts: 41
- Joined: Mon Nov 28, 2011 3:30 pm
- Location: Logandale, Nevada
Re: WORK SESSION A - Friday, May 24, 2014
by Joe Kanocz » Sat May 24, 2014 7:57 pm
I caught some photos in Antonito on Friday
Lunch time
Wood truck parts for the new cook car trucks
Truck parts for the RPO
Amazing work by Russ Hanscom. These truck parts were torch cut out of steel and finished.
Marshall Smith is running the metal band saw
Valley Lowrince is painting siding for a later work session. This siding is going to be installed at Sublette.
Lunch time
Wood truck parts for the new cook car trucks
Truck parts for the RPO
Amazing work by Russ Hanscom. These truck parts were torch cut out of steel and finished.
Marshall Smith is running the metal band saw
Valley Lowrince is painting siding for a later work session. This siding is going to be installed at Sublette.
- Joe Kanocz
- Moderator
- Posts: 580
- Joined: Thu Nov 17, 2011 5:06 pm
2 posts
• Page 1 of 1
Return to Work Session A (May 19-23)
Who is online
Users browsing this forum: No registered users and 0 guests