Page 1 of 1
CNC capable woodworking available
Posted:
Tue Dec 13, 2011 10:27 amby Russ Wood
I have a CNC woodworking shop. I am still in the learning stages of using this equipment but I can produce prototypes of a project before final cutting to insure you get the desired results. I can produce simple routed signs to more detiled 3d carving pieces. If you are willing to work with me I am willing to give most projects a try.
Russ
Chiloquin Oregon
russ at hobby-tronics dot com
Re: CNC capable woodworking available
Posted:
Tue Dec 13, 2011 11:41 amby John Cole
Hi Russ, did you try to contact Craig, Ed, or John Engs yet? If you have no luck, please PM me, John
Re: CNC capable woodworking available
Posted:
Tue Dec 13, 2011 2:40 pmby Russ Wood
Yes, contacted both and both have already replied. Thanks.
Re: CNC capable woodworking available
Posted:
Tue Dec 13, 2011 2:46 pmby John Cole
I talked to John on the phone and told him to check out the photo of your shop you posted here, most impressive! He is hoping that you can help them out with some of the passenger car woodworking.
Re: CNC capable woodworking available
Posted:
Fri Dec 23, 2011 9:30 amby John Cole
Hi Russ, I assume you have seen the Colorado Springs blog site, and perhaps you see some of the woodworking that is going into the passenger cars.
Re: CNC capable woodworking available
Posted:
Fri Dec 23, 2011 10:19 amby Russ Wood
Yes, and I have been in contact with the 463 folks as well, thanks. Russ