CNC capable woodworking available

[Russ Wood]

I have a CNC woodworking shop. I am still in the learning stages of using this equipment but I can produce prototypes of a project before final cutting to insure you get the desired results. I can produce simple routed signs to more detiled 3d carving pieces. If you are willing to work with me I am willing to give most projects a try.



Russ
Chiloquin Oregon

russ at hobby-tronics dot com

[John Cole]

Hi Russ, did you try to contact Craig, Ed, or John Engs yet? If you have no luck, please PM me, John

[Russ Wood]

Yes, contacted both and both have already replied. Thanks.

[John Cole]

I talked to John on the phone and told him to check out the photo of your shop you posted here, most impressive! He is hoping that you can help them out with some of the passenger car woodworking.

[John Cole]

Hi Russ, I assume you have seen the Colorado Springs blog site, and perhaps you see some of the woodworking that is going into the passenger cars.

[Russ Wood]

Yes, and I have been in contact with the 463 folks as well, thanks. Russ